Wednesday, June 3, 2015

Deep Fried Turkey

This year my mother-in-law wanted to host Thanksgiving, but not to cook the turkey.  Since I volunteer for assignments, turkey-cooking fell on my shoulders.  Since everything I do must be an over-wrought project, this turkey got deep fried.

The Bird:  14 lbs., organic turkey from Costco

The Brine: An essential step.  This brine was composed of (total 1 gallon):

  • 1 cup salt
  • 1/2 cup brown sugar
  • a slug of maple syrup
  • 1/2 cup of apple cider vinegar
  • shot of Worcestershire sauce
  • several sprigs of thyme
  •  half an onion
  • a few stalks of celery
  • a cinnamon stick
This was applied to the turkey overnight.

After brining for 12+ hours, the turkey was added to the fryer pot and the displacement level of water measured (just enough to fully submerge the bird).  This is a critical step, as an overflow could = a fire.

Next the bird was dried (another critical step, water + hot oil is a disaster).

Next the turkey was injected with butter, and rubbed with butter and a Cajun dry-rub.

Now to the outdoor setup:


The fryer was set up outside, on a flat surface, away from structures.  Note the fire extinguisher, lighter, and heat glove (also the essential beer).  Once sparked, the ~ gallon of (peanut) oil took about 30 minutes to reach the start temp of 325 degF.  The goal is to cook primarily from 350-375 degF, so once the the bird goes in @ 325, crank the heat up.

Then let the bird cook in the oil bath:

Figure 3 minutes per pound = 45 minutes.  After the time had elapsed the turkey was slooowly pulled out using the reach hook.  Finally, the turkey rested for 15 minutes before carving.

Results: one of the best birds I've ever cooked.

Sous Vide Porchetta Part 2

Yesterday I attempted to make Sous Vide style Porchetta.  The procedure:

After roughly 24 hours at in the water bath, I pulled the meat out.


The meat at this point is almost comically tender.  Wrapped around the meat, the fat layer more closely feels like jelly.  I needed to use care when handling.  However, I didn't want a gelatinous outer layer. The goal is to have a crisp outer shell and juicy interior.  The only solution: deep fry.


375 degF for ~4 minutes on each side.  The results:


This is probably the most tender pork you can conceivably make.  It also is stupidly rich and heavy.  Despite the heavy rub yesterday, I still felt like the pork needed more salt.  Further, I think 4 minutes was not enough time to get the crisp I was hoping for.  Next time I will increase the rub and the time in the fryer.  Still a fun and tasty project to make.  Pair with a strong ale that can stand up to the meat's richness.

Sous Vide Porchetta

I began experimenting with Sous Vide cooking style with a DIY unit.  This particular setup is called Frankenstein: a cheap Temperature Control Unit powering a $9 used, dumb, slow cooker.  All that is really required is a source of heat (an element or dumb crockpot or rice cooker) and a means to control it.

But what to use in my toy?   Porchetta.

Step 1.  Acquire pork belly.  $5 @ Whole Foods.
Step 2.  Scour the meat

Step 3.  Rub.  Apply the following liberally:
  • Salt
  • Pepper
  • Red Pepper Flakes
  • Fennel
  • Thyme
  • Garlic Powder
I ground the fennel, thyme and pepper flakes with a mortar and pestel

Step 4.  Roll it.  Wrap it with twine.  Rub salt on the fat side.


Step 5.  Bag it.  Try to remove as much air as possible.  Since I don't usually break out the vacuum sealer, I use ziplock bags instead.  The water displacement method works the best.

Step 6.  Add it to the water bath.  I set the controller for 158 degF.  The meat went in at 9 pm the evening before dinner.  The bag is weighed down to ensure it is submerged.

Stayed tuned till tomorrow for the followup.